Filter
Top Products
Control Panel 95
4
4
4
4
4
4
4
4
4
4
4
4
Changing default settings
Follow these steps to enter the Default Setting mode and change
the printer’s default settings:
Note:
❏ To print the language selection instructions and Default Setting
mode instructions, you need five sheets of A4 or Letter size
single-sheet paper, or five pages of continuous paper that is at least
279 mm (11 inches) long and 210 mm (8.27 inches) wide.
❏ If you use single sheets without an optional cut-sheet feeder, you
need to feed a new sheet of paper each time the printer ejects a printed
sheet.
1. Make sure paper is loaded and the printer is turned off.
c
Caution:
Whenever you turn off the printer, wait at least five seconds
before turning it back on; otherwise, you may damage the
printer.
2. While holding down the Tear Off (Font) button, turn on the
printer. The printer enters the Default Setting mode and prints
the language selection instructions (one page).
3. Follow the instructions to select the language you want for
the instruction pages.
4. Load the next sheet of paper, if necessary. The printer prints
the current settings list (one page).
5. Press down the Tear Off (Font) button. The printer prints the
Default Setting mode instructions (three pages) in the
language you selected. The printed instructions list the
default settings you can change, describe how to change them,
and show you how the control panel lights help you make
settings.