Filter
Top Products
124 Appendix A: Projector Installation
If you’re mounting the projector on the ceiling and you place it above
screen level, you’ll have to tilt it down to position the image on-screen.
This causes the image to lose its square shape. You can then correct
the distortion by using the
Keystone function in the projector’s
menu system (see page 71) or by using the
Keystone buttons on the
projector’s control panel.
If you place the projector so that the base of the lens is level with the
bottom of the screen, the image will be square and you won’t have to
adjust it. If you place the lens lower than the bottom of the screen,
you’ll have to tilt the projector upward if you want to fill the whole
screen with the image.
If you want to be able to control the projector’s settings from a remote
computer, see Chapter 5.
You can also use the remote control to operate more than one
projector. See page 63.
warning
When installing or
adjusting the ceiling
mount, do not use
adhesives to prevent the
screws from loosening and
do not use any type of oil or
lubricant. These may cause
the projector casing to
crack and the projector
may fall, causing serious
injury and serious damage
to the projector.