Filter
Top Products
82 Fine-tuning the Projector
6. Press
Menu to close the Password Protect menu.
7. Turn off the projector and unplug the power cord to enable
password protection.
When you turn the projector on again, you will need to enter a
password. Follow the instructions in the next section.
Starting the Projector with a Password
When the password function is enabled, you see this screen when you
turn on the projector:
Press down the
Num button on the remote control as you use the
numeric keypad buttons to enter the password. Once you have
entered the password correctly, the password screen closes, and
projection begins.
If the password is not correct, you see the message
Wrong password.
Please try again.
If you enter an incorrect password three times in
succession, you see the message
The projector’s operation will be
locked. Request code xxxxx
and the projector switches to standby
mode for approximately 5 minutes. Write down the request code.
Then disconnect the projector’s power cord from the electrical outlet,
reconnect it, and turn the projector back on.
When you see the Password Protect Release screen again, you can try
to enter the correct password.
note
If you lose the remote
control, you will not be able
to enter the password, so
keep the remote control in a
safe place at all times.
note
When the period defined in
the
Time-elapsed setting
has passed, and the password
is entered correctly, the
elapsed time will be reset to
0 and the countdown will
start again. Remember to
disable or change this setting
when you need to.
Password
Enter the password.
[0
-
9]:Enter[0-9]:Enter
#Refer to the "User’s Guide" for the operation.