Filter
Top Products
Fine-tuning the Projector 81
The password will be displayed as ****. After you enter the last
digit, a confirmation screen appears. Enter the password again.
5. After you finish setting the password, press the
Esc button to
return to the Password Protect menu.
6. Press the
Num button on the remote control to turn off the
numeric keypad.
Make a note of the password and keep it in a safe place in case you
forget it.
Turning On Password Protect and User’s Logo
Protect
1. To enable the password, press the Freeze button on the remote
control for about 5 seconds until you see the Password Protect
menu.
2. Select
Power ON Protect and press Enter.
3. Select
ON and press Enter. Then press Esc.
4. If you want to disable the password temporarily, select
Timer and
press
Enter. Then hold down the Num button while you use the
numeric keypad to enter the number of hours (from 0 to 9999)
that you want the password feature disabled. If you want the
projector to request the password every time it is turned on, set
the timer to
0H. Press Enter when you’re done.
The countdown for the elapsed time begins as soon as you close
the Password Protect menu. (You can check the elapsed time in
this menu next to
Time elapsed.)
5. To turn User’s Logo Protect on, select
User’s Logo Protect and
press
Enter. Select ON and press Enter.
When this feature is on the logo appears whenever the projector is
turned on (if the
No-Signal Msg. is set to Logo on the Setting
menu; see page 80) and as the A/V Mute screen (if you selected
the
Logo as the A/V Mute setting in the Setting menu). None of
the User’s Logo features can be changed when the User’s Logo
Protect function is enabled.
note
If you make a mistake
entering the time, press the
Esc button and enter the
time again.