Filter
Top Products
88 Managing the Projector from a Remote Computer
3. Press the
Menu button on the remote control and select Network
from the
Advanced2 menu.
4. If your network assigns addresses automatically, turn on
DHCP.
5. If your network does not assign addresses automatically, turn off
DHCP and enter the projector’s IP Address, Subnet Mask,
Gateway Address, and MAC Address, as needed.
■ To enter numbers using the remote control, press the Num
button until it lights, then use the number keypad shown
below.
Brightness Control
Brightness Control
High
High
Low
Low
:
Video
Video
Audio
Audio
Setting
Setting
User's Logo
User's Logo
Advanced1
Advanced1
About
About
Reset All
Reset All
Projector ID
Projector ID
Network
Network
Reset
Reset
Execute
Execute
: 1
: 1
[Menu]: Exit
[Menu]: Exit
[ ]: Enter
[ ]: Enter
[ ]: Select
[ ]: Select
Effect
Effect
Advanced2
Advanced2
COM Port
COM Port
BNC Sync Termination
BNC Sync Termination
:
ON
ON
OFF
OFF
:
Set
Set
Set
Set
RS-232C
RS-232C
USB
USB
Auto setup
Auto setup
ON
ON
OFF
OFF
:
Select Network
note
If you’re a network
administrator, you can use
the
SNMP option to enter a
trap IP address. This lets you
receive trap alerts for the
projectors you’re monitoring.
If you have HP OpenView,
a plug-in will be available
to allow you to manage your
projectors in HP OpenView.
Check with your dealer or
Epson for availability (see
page 121).
Num button
Zero