Filter
Top Products
Projecting 49
Adjusting Color Corrections for a New Surface
Adjust the correction values if you’re projecting on a new surface or in
a new location.
1. Press the
Wall Shot button on the remote control or projector
while you’re projecting an image. Wait for the Wall Shot status
screen.
2. Press the
Wall Shot button until you see Wall Shot
Readjustment
on the status screen.
You see a sequence of colors flash for about five seconds as the
projector adjusts the color correction values for the new
projection surface.
Shutting Down the Projector
When you’ve finished using the projector, follow the recommended
procedure to shut it down. This extends the life of the lamp and
protects the projector from possible overheating.
1. Turn off and disconnect any equipment plugged into the
projector.
2. To turn off the projector, press the red P
Power button on the
projector or remote control.
You see a confirmation message. (If you don’t want to turn it off,
press any other button.)
note
When the projector has not
received any input signals
f
or 30 minutes, it
automatically turns off the
p
rojector lamp and enters
“sleep mode.” This conserves
electricity, cools the
p
rojector, and extends the
life of the lamp. If you want
to start projecting again,
p
ress the P Power button.
If you are done using the
p
rojector, unplug the power
cord. To turn off sleep mode,
see page 76.
Turn off this product when
not in use to prolong the life
of the projector.
Power button
Power OFF?
Power OFF?
Yes
Yes
:
:
Press button
Press button
No
No
:
:
Press any other button
Press any other button