Filter
Top Products
80 Fine-tuning the Projector
5. Select the screen(s) on which you want your image to appear:
■ Select No-Signal Msg. if you want to display your image
(instead of a blank screen) when there is no video signal
incoming from the currently selected source. Then select
Logo.
■ Select A/V Mute if you want your image to appear when you
press the
A/V Mute button. Then select Logo and press
Enter.
6. To display the logo as the startup screen, select the
Setting menu.
7. Select
No-Signal Msg. and press Enter. Then select Logo and
press
Enter.
8. Press
Esc.
9. To display the logo as the background screen when the A/V Mute
button is press, select the
A/V Mute and press Enter.
10. Select
Logo and press Enter.
11. When you’re finished, press
Menu to exit the menus.
Setting a Password
1. Press the Freeze button on the remote control for about 5
seconds until you see the Password Protect menu:
2. Select
Password and press Enter. You see the message Change
the password?
3. Select
Yes and press Enter.
4. Hold down the
Num key on the remote control and use the
numeric keypad to enter a 4-digit password.
note
If a password has already
been set, you see the
Password Protect Release
screen. See “Starting the
Projector with a Password”
on page 82.
Password Protect
ON: OFF
Password Timer
Power ON Protect
Set
[ / ] :Select [ ] :Set
Set 9999H
Timer
0H
Time-elapsed
User’s Logo Protect
Passward
ON: OFF
ON: OFF
:
[Menu] :Exit