Filter
Top Products
Managing the Projector from a Remote Computer 89
■ To change the network addresses from the projector’s control
panel, press the right and left arrow buttons to select the part
of the address you want to enter, then use the up and down
arrow buttons to increase or decrease the numeric value.
When you finish changing an address in the network menu, press
the
Enter button (on the remote control) or the Auto/Enter
button (on the projector). This stores the value.
6. When done making all necessary changes, press
ESC to exit the
menu system.
Using EMP Monitor
EMP Monitor lets you manage all your projectors using a remote
computer. This lets you easily turn the projectors on or off (together
or individually), switch image sources, and check on their status.
Before using EMP Monitor, make sure you’ve installed the software as
described on page 86. The computer you’re using to monitor the
projector should already be connected to your network.
Increase
or
decrease
the value
Select the
part of the
address to
change