Filter
Top Products
EPSON Stylus C63/64/83/84 Revision A
Adjustment Overview 35
2.1 Overview
This section describes the procedure for adjustments required when the printer is
disassembled and assembled for repair or service.
2.1.1 Required Adjustment
If you remove or replace the specific part in your service/repair, you have to perform
the appropriate adjustment as listed Table 5-1 below.
In this printer, it is necessary to perform appropriate adjustment in order to maintain
consistent printing function and quality, eliminate differences of each printer
mechanism’s characteristics.Therefore, in case that the combination between the
printer mechanism and the main board changes or the Printhead is replaced during the
repair service, you must input the correct adjustment value into the EEPROM on the
Main board by using the Adjustment program
Flowchart 2-1. Required adjustment flowchart
C H E C K
P O I N T
In case that any parts are removed and assembled on the repair
product while running the Adjustment program, make sure to
turn off the printer.
*175+0)
#5(7PKV
*QNFGT5JCHV7PKV
/CKP$QCTF
25$QCTF
2CTV
(TCOG(TQPV
%4WPKV+PENWFG2TKPV*GCF
%4/QVQT
4QNNGT'LGEV
2CRGT)WKFG
2CTV
2CTV
*QWUKPI.QYGT
+PM5[UVGO
2CRGT)WKFG7RRGT
2(/QVQT