Filter
Top Products
FCC COMPLIANCE STATEMENT FOR AMERICAN USERS
This equipment generates and uses radio frequency energy and if it is not installed
and used properly, that is, in strict accordance with the manufacturer’s instructions, it
may cause interference to radio and television reception. It has been type tested and
found to comply with the limits for a Class B computing device in accordance with
the specifications in Subpart J of Part 15 of FCC
ru es, which are designed to provide
l
reasonable protection against such interference in a residential installation. However,
there is no guarantee that interference will not occur in a particular installation. If
this equipment does cause interference to radio and television reception, which can
be determined by turning the equipment off and on, you are encouraged to try to
correct the interference by one or more of the following measures:
l Reorient the receiving antenna
l
Relocate the computer with respect to the receiver
l
Move the computer away from the receiver
l
Plug the computer into a different outlet so that the computer and receiver are
on different branch circuits.
If necessary, consult your dealer or an experienced radio/television technician for
additional suggestions, You may find the following booklet prepared by the Federal
Communications Commission helpful:
“Television Interference Handbook”
This booklet is available from the U.S. Government Printing Office, Washington DC
20402. Stock No. 004-000-00450-7
Note: If the interference stops, it was probably caused by the computer or its periph-
eral devices. To further isolate the problem:
Disconnect the peripheral devices and their input/output cables one at a time. If the
interference stops, it is caused by either the peripheral device or its I/O cable. These
devices usually require shielded I/O cables. For Epson peripheral devices, you can
obtain the proper shielded cable from your dealer. For non-Epson peripheral devices,
contact the manufacturer or dealer for assistance.
WARNING: This equipment has been certified to comply with the limits for a
Class B computer device, pursuant to Subpart J of Part 15 of FCC Rules. Only
peripherals (computer input/output devices, terminals, printers, etc.) certified to
comply with the Class B limits may be attached to this computer. Operation with
noncertified peripherals is likely to result in interference to radio and TV
reception.
The connection of a nonshielded equipment interface cable to this equipment will
invalidate the FCC Certification of this device and may cause interference levels
that exceed the limits established by the FCC for this equipment.
This digital apparatus does not exceed the Class B limits for radio noise emissions
from digital apparatus as set out in the radio interference regulations of the Canadian
Department of Communications.
Le present appareil
numerique
n’emet pas de bruits radioelectriques
depassant
les
limites
applicables
aux appareils
numeriques
de
Classe
B
prescrites
dans le reglement
stir
le brouillage radioelectriques edict6 par le
Minis&e
des Communications du
Canada.