Filter
Top Products
and then press the
ON LINE
button. The printer starts printing from the
point at which it was stopped.
If you turn your printer off during the time the printer detects a paper
out or paper jam condition, any data remaining in the printer’s buffer is
discarded.
Software operation
This command causes the printer to eject the sheet in the printer without
loading the next sheet:
FF
form feed
The sheet in the printer is automatically ejected and the next sheet is
loaded if the paper reaches the bottom of the print area when any of the
following line feed commands is used:
LF
VT
ESC J
line feed; advances the paper by one line
vertical tab; advances the paper to the next vertical tab
position
performs line feed in units of
l/216
of an inch.
Setting up your software
When you switch between continuous paper and cut sheet feeder paper
you usually need to change the settings of your software program.
Because of the physical requirements of
feeding
a single sheet of paper,
sheet feeders create a top and bottom margin on each sheet. To work
properly, your software program needs to know how many printable
lines are available on the page.
Paper comes in many different sizes and it is sometimes difficult to know
exactly how many printable lines per page you have. When you perform
a self test in sheet feeder mode, the printer automatically counts and
prints
the
number of lines that are available on
any
size of paper. This is
the number of lines you should use as the page length in your software
setup. See the following section on the self test in cut sheet feeder mode
for more details.
Using Printer Options
7-9