Filter
Top Products
ESC EM
Turn Cut Sheet Feeder Mode On/Off
Format:
ASCII code:
ESC EM n
Decimal :
27 25 n
Hexadecimal: 1B 19 n
Comments:
The following values can be used for n:
4: Mode is turned ON.
0: Mode is turned OFF.
The variables are the characters “0” (48 decimal) and “4” (52 decimal).
The command should not be used unless the cut sheet feeder is
installed. It is ignored if any value other than “0” or “4” is used for n.
The mode can also be turned on or off with DIP switch 2-2.
MSB control
Note: MSB is the Most Significant Bit.
MSB control (ESC =, ESC>,
and ESC #) is not valid for graphics or user-defined characters.
ESC = (equal)
Set MSB to 0
Format:
ASCII code:
ESC =
Decimal:
27 61
Hexadecimal: 1B 3D
Comments:
Sets the MSB of all incoming data to 0. Some computers always send
data with the MSB set to
1,
which means that italics or character
graphics are always printed. ESC = can overcome this problem.
Command Summary
8-11