Filter
Top Products
A list of your printer’s settings is printed first, followed by a series of
characters. Here is part of a typical draft self test:
4. The self test continues until the paper runs out or until you press the
ON LINE
button. To stop the test temporarily, press the
ON LINE
button to take the printer off line.
5.
To end the self test, be sure
the
printer is off line. Press the
LOAD/
EJECT
button to eject any paper that is still loaded, and then turn off
the printer.
Note: When the cut sheet feeder is installed, the self test printout is
slightly different. For details, see the
section on the cut sheet feeder in
Chapter 7.
To run the self test in NLQ mode, follow these steps:
1.
Load another
sheet
of paper as described above.
2. Turn off the printer, then turn it on again while holding down the
FORM FEED
button. After printing starts, release the
FORM FEED
button.
Setting
Up the Printer
1-17