Filter
Top Products
2
❏
Unplug the printer and refer servicing to qualified service
personnel under the following conditions:
The power cord or plug is damaged; liquid has entered the
printer; the printer has been dropped or the cabinet damaged;
the printer does not operate normally or exhibits a distinct
change in performance.
❏
If you plan to use the printer in Germany, observe the
following:
To provide adequate short-circuit protection and over-
current protection for this printer, the building installation
must be protected by a 16 Amp circuit breaker.
Bei Anschluß des Druckers an die Stromversorgung muß
sichergestellt werden, daß die Gebäudeinstallation mit einem
16 A-Überstromschalter abgesichert ist.
A Few Precautions
When using the printer
❏
Do not put your hand inside the printer or touch the ink
cartridges during printing.
❏
Do not move the print head by hand; otherwise you may
damage the printer.
❏
Always turn the printer off using the
P
Power
button. When
this button is pressed, the Power light flashes briefly then goes
off. Do not unplug the printer or turn off the power to the
outlet until the Power light stops flashing.
❏
Before transporting the printer, make sure the print head is in
the home (far right) position and the ink cartridges are in
place.