Filter
Top Products
14
The default LAN IP address is 192.168.0.1 and the default subnet mask is 255.255.255.0. In most
cases, these default settings need no change.
As for the WAN IP address, it is obtained by DHCP from the ISP. The Trigger mode setting affects
the behavior of the DHCP client of the Router. In Auto mode, you don’t have to worry about the
DHCP process; the device takes care of everything. In Manual mode, there are two buttons on the
Start page for you to manually release an obtained IP address (Release) and re-obtain a new one from
a DHCP server (Renew).
2.4.3.3. Router with a Static-IP DSL/Cable Connection
Fig. 12. TCP/IP settings for Router with a Static-IP DSL/Cable Connection mode.
In this mode, two IP addresses are needed—one for the Ethernet LAN interface and the other for the
WAN interface. The LAN IP address must be set manually to a private IP address, say 192.168.0.xxx.
The default LAN IP address is 192.168.0.1 and the default subnet mask is 255.255.255.0. In most
cases, these default settings need no change.
As for the WAN IP address, it must be manually set. Consult your ISP for the correct IP address,
Default Router, Subnet mask, Primary DNS server, and Secondary DNS server settings.
2.4.3.4. Router with a Multiple DSL/Cable Connections