Filter
Top Products
The Cut Sheet Feeder
The following is a typical example of a software setup required for
proper operation of your cut sheet feeder. Not all software is set up
the same, so you may find that a bit of experimentation is required
before you find the best equivalent settings to use.
To maintain 54 printed lines per page:
Continuous
Cut sheet
form settings
feeder settings
Change Page
Length from
66
Change Top
Margin from
6
to
to
61
4
Change
Bottom
Margin from
6
to
3
Many word processors and other software give you two ways to
change these settings:
l
You can change the settings in each individual file you print or;
l
You can change the program’s default settings so that every time
you use the program, these new settings are in effect.
If your program has additional features, such as headers and
footers, you have to compensate accordingly.
Control panel operation
All of the functions from the control panel are available in cut sheet
feeder mode. Micro adjustment of the loading position is available
immediately after loading a sheet using the LOAD/EJECT button and
pushing the ON LINE button. Micro adjustment sets a new sheet loading
position for as long as the power remains on. If the power is turned
off, the loading position is returned to the factory setting. Changing
the loading position with micro adjustment affects the number of lines
per page. You may need to change your software margin settings
again for this new page length.
7-13