Filter
Top Products
5-46 Commands
• This command sets the distance from the current position to [(
nL
+
nH
✕
256)
✕
vertical or horizontal motion unit] inches.
[Notes] • This command is ignored Unless page mode is selected.
• When pitch
N
is specified to the movement downward:
nL
+
nH
✕
256 =
N
When pitch
N
is specified to the movement upward (the negative
direction), use the complement of 65536.
When pitch
N
is specified to the movement upward:
nL
+
nH
✕
256 = 65536 -
N
• Any setting that exceeds the specified printing area is ignored.
• The reference position is that at which data development starts.
• This command function as follows, depending on the print
starting position set by ESC T:
1 When the starting position is set to the upper left or lower left of
the printing area, the vertical motion unit (y) is used.
2 When the starting position is set to the upper right or lower left
of the printing area, the horizontal motion unit (x) is used.
• The horizontal and vertical motion unit are specifide by GS P.
•The GS P command can change the horizontal (and vertical)
motion unit. However, the value cannot be less than the minimum
horizontal movement amount, and it must be in even units of the
minimum horizontal movement amount.
[Reference] ESC $,ESC T, ESC W, ESC \, GS $, GS P
GS ^
r t m
[Name] Execute macro
[Format] ASCII GS ^
r t m
Hex 1D 5E
r t m
Decimal 29 94
r t m
[Range] 0
≤
r
≤
255
0
≤
t
≤
255
0
≤
m
≤
1
[Description] Executes a macro.
•
r
specifies the number of times to execute the macro.
•
t
specifies the waiting time for executing the macro.
The waiting time is
t
✕
100 msec for every macro execution.
•
m
specifies macro executing mode.
• When the LSB
m
= 0:
The macro executes
r
times continuously at the interval specified by
t
.
• When the LSB
of m
= 1: