Filter
Top Products
Commands 5-37
• The horizontal starting buffer position does not move.
‘ • The reference starting position is that specified by ESC T.
• This command operates as follows, depending on the starting
position of the printing area specified by ESC T:
➀
When the starting position is set to the upper left or lower right,
this command sets the absolute position in the vertical
direction.
➁
When the starting position is set to the upper right or lower left,
this command sets the absolute position in the horizontal
direction.
• The horizontal and vertical motion unit are specified by GS P.
•The GS P command can change the horizpntal and vertical
motion unit.However, the value cannot be less than the minimum
horizontal movement amount, and it must be in even units of the
minimum horizontal movement amount.
[Reference] ESC $, ESC T, ESC W, ESC \, GS P, GS \,
GS
✻
x y
[
d
]
x
✕
y
✕
8
[Name] Define downloaded bit image
[Format] ASCII GS
✻
x y
[
d
]
x
✕
y
✕
8
Hex 1D 2A
x y
[
d
]
x
✕
y
✕
8
Decimal 29 42
x y
[
d
]
x
✕
y
✕
8
[Range] 1
≤
x
≤
255
1
≤
y
≤
48
x
✕
y
≤
1536
0
≤
d
≤
255
[Description] Defines a downloaded bit image using the dots specified by
x
and
y
.
•
x
indicates the number of dots in the horizontal direction.
•
y
indicates the number of dots in the verticall direction.
•
The number of dots is
x
✕
8 in the horizontal direction and
y
✕
8 in
the vertical direction.
•
d
indicates bit-image data. Set bit to 1 to print a dot and to 0 to not
print a dot.
[Notes] • If
x
✕
y
is outside of the specified range, the printer ignores this
command.
• A user-defined character and a downloaded bit image cannot be
defined simultaneously. When this command is executed, the
user-defined character is cleared.
• After a downloaded bit image is defined, it is available uutil ESC
@ or ESC & is executed; the printer is reset; or the power is turned
off.