Filter
Top Products
Commands 5-7
•Even if DLE ENQ 2 is executed, the printer retains the settings (by
ESC !, ESC 3, etc.) that were in effect when the error occurred. The
printer can be initialized completely by using DLE ENQ and ESC
@.
[Reference] DLE EOT
CAN
[Name] Cancel print data in page mode
[Format] ASCII CAN
Hex 18
Decimal 24
[Description] In page mode, deletes all the print data in the current printable area.
[Notes] • This command is enabled only in page mode.
• If data that existed in the previously specified printing area also
exists in the currently specified printing area, it is deleted.
[Reference] ESC L ESC W
ESC FF
[Name] Print data in page mode
[Format] ASCII ESC FF
Hex 1B 0C
Decimal 27 12
[Description] In page mode, prints all buffered data in the printing area
collectively.
[Notes] • This command is enabled only in page mode.
• After printing, the printer does not clear the buffered data, setting
values for ESC T and ESC W, and the position for buffering
character data.
[Reference] FF, ESC L, ESC S
ESC SP
n
[Name] Set right-side character spacing
[Format] ASCII ESC SP
n
Hex 1B 20
n
Decimal 27 32
n
[Range] 0
≤
n
≤
255
[Description] Sets the character spacing for the right side of the character to [nx
horizontal or vertical motion units].
[Notes] • The right-side character spacing for double-width mode is twice
the normal value. When characters are enlarged, the right-side
character spacing is
n
times normal value.
• This command sets values independently in each mode (standard
and page modes).