Filter
Top Products
Installation 1-19
Adjusting the Paper Near End Detector
The paper near end detector detects when the paper is almost gone
by measuring the diameter of the paper roll. Software programs
can use the ESC c 4 command to stop printing when the paper is
almost gone.
If you want to change the amount of paper remaining when the
printer stops printing, follow the steps below to adjust the paper
near end detector.
Note:
The printer also has a paper end-detector that stops the printer at the
very end of a roll. This detector cannot be turned off by software.
1. Open the printer cover and remove the paper roll.
2. Locate the adjusting screw and the positioning plate shown in
the illustration below.
3. Loosen the adjusting screw with a coin or a screwdriver.
Adjusting screw
Positioning plate