Filter
Top Products
5-10 Commands
• The distance from the beginning of the line to the print position is
[(
nL
+
nH
✕
256)
✕
(vertical or horizontal motion unit)] inches.
[Notes] • Settings outside the specified printable area are ignored.
• The horizontal and vertical motion unit are specified by GS P.
•The GS P command can change the horizontal (and vertical)
motion unit. However, the value cannot be less than the minimum
horizontal movement amount, and it must be in even units of the
minimum horizontal movement amount.
• In standard mode, the horizontal motion unit (
x
) is used.
• In page mode, horizontal or vertical motion unit differs
depending on the starting position of the printable area as follows:
1 When the starting position is set to the upper left or lower right
of the printable area using ESC T, the horizontal motion unit (
x
)
is used.
2 When the starting position is set to the upper right or lower left
of the printable area using ESC T, the vertical motion unit (
y
) is
used.
[Reference] ESC \, GS $, GS \, GS P