Filter
Top Products
5-48 Commands
[Notes] • If any of the status items in the table above are enabled, the printer
transmits the status when this command is executed. The printer
automatically transmits the status whenever the enabled status
item changes. The disabled status items may change, in this case,
because each status transmission represents the current status.
• If all status items are disabled, the ASB function is also disabled.
• The following four status bytes are transmitted without
confirming whether the host is ready to receive data. The four
status bytes must be consecutive, except for the XOFF code.
• Since this command is executed sfter the data is processed in the
receive buffer, there may be a time lag between data reception and
status transmission.
• When the printer is disabled by ESC =, this command is disabled
but ASB is not disabled.
• When using DLE EOT, ESC u, ESC v, GS I, or GS r, the status
transmitted by these commands and ASB status must be
differentiated.
• The status to be transmitted are as follows:
First byte (printer information)
Bit Off/On Hex Decimal Status for ASB
0 Off 00 0 Not used. Fixed to Off.
1 Off 00 0 Not used. Fixed to Off.
2
Off 00 0 Drawer kick-out connector pin 3 is LOW
On 04 4 Drawer kick-out connector pin 3 is HIGH.
3
Off 00 0 On-line.
On 08 8 Off-line.
4 On 10 16 Not used. Fixed to On.
5
Off 00 0 Cover is closed.
On 20 32 Cover is open.
6
Off 00 0
Paper is not being fed by the
PAPER FEED
button.
On 40 64 Paper is being fed by the
PAPER FEED
button.
7 Off 00 0 Not used. Fixed to Off.