Filter
Top Products
5-20 Commands
• When the LSB of
n
is 0, emphasized mode is turned off.
• When the LSB of
n
is 1, emphasized mode is turned on.
[Notes] • Bit image and downloaded bit image , and bar code cannot be
emphasized.
• ESC ! also turns on and off emphasized mode. However, the last
received command is effective.
[Default]
n
= 0
[Reference] ESC !
ESC G
n
[Name] Turn on/off double-strike mode
[Format] ASCII ESC G
n
Hex 1B 47
n
Decimal 27 71
n
[Range] 0
≤
n
≤
255
[Description] Turns double-strike mode on or off.
• When the LSB of
n
is 0, double-strike mode is turned off.
• When the LSB of
n
is 1, double-strike mode is turned on.
[Notes] • Printer output is the same in double-strike mode and in
emphasized mode.
• Double-strike mode can not be used for the bit image,
downloaded bit image, and bar code.
[Default]
n
= 0
[Reference] ESC E
ESC J
n
[Name] Print and feed paper
[Format] ASCII ESC J
n
Hex 1B 4A
n
Decimal 27 74
n
[Range] 0
≤
n
≤
255
[Description] Prints the data in the print buffer and feeds the paper [
n
x vertical or
horizontal motion unit] inches.
[Notes] • After printing is completed, this command sets the print starting
position to the beginning of the line.
• The paper feed amount set by this command does not affect the
values set by ESC 2 or ESC 3.
• The horizontal and vertical motion unit are specified by GS P.
• The GS P command can change the vertical (and horizontal)
motion unit. However, the value cannot be less than the minimum
vertical movement amount, and it must be in even units of the
minimun vertical movement amount.