Filter
Top Products
Leaving the Setup program
When you finish using the Setup program, press
t
until the
cursor block is on Exit and press Enter. The screen displays a
list of the current settings you just made. Check the list to
make sure all the information is correct.
Below the list you see this menu:
Change settings
Exit
without saving
* * EXIT AND SAVE * *
If any setting is incorrect, press Enter. The main Setup menu
is displayed again, and you can correct the setting.
If you did not make any changes or if you want to cancel
the changes you made, press
1
to select Exit without saving,
and press Enter.
When the settings are correct, press
1
to select * * EXIT
AND SAVE * *, and press Enter. At this point, the program
resets the computer using the new configuration. If the
reference diskette is in drive A, remove it and insert the
MS-DOS diskette in the drive.
If the computer displays a Setup error message during the
power-on self test, run Setup again and check all your settings.
Note
If you have the hard disk model Equity LT, go on to
Chapter 2 and complete all the procedures there to prepare
your hard disk for use. If you do not have a hard disk, go on
to Chapter 3.
1-28
Setting Up Your System