Filter
Top Products
and press Enter. MS-DOS prompts you to insert your
diskettes:
Insert SOURCE diskette in drive A:
Insert TARGET diskette in drive B:
Press any key when ready . .
4.
Insert the diskette you want to copy from in drive A and
the diskette you want to copy to in drive B. Then press
any key.
DISKCOPY checks to see if the target diskette is formatted.
If it is not, DISKCOPY formats the diskette. You see the
message:
Formatting while copying
The copy operation begins when the format is complete.
You see this message:
Copying 80 tracks
9 Sectors/Track, 2 Side(s)
5.
When the copy is complete, you see this message:
Copy another diskette (Y/N)?
Your diskette has now been copied and you can either
make another copy or leave the DISKCOPY command.
Press Y to perform another copy or N to end the
DISKCOPY command.
Copying with one 3
f
-inch diskette drive
1.
First be sure your original diskette is write-protected.
(See Chapter 3 for instructions.)
2.
Insert the working copy of your MS-DOS system diskette
in drive A or type C: to log on to drive C, the hard disk.
3. At the A> or C> prompt, type:
DISKCOPY
and press Enter.
Using MS-DOS With the Equity LT
4-9