Filter
Top Products
3. Remove any diskettes, then turn off the power switches on
the monitor and the main unit. Check that the monitor’s
power cable is securely connected to the monitor and to an
electrical outlet, and that the monitor cable is properly
connected to both the monitor and the main unit. Then
turn both power switches back on.
4. Be sure DIP switch 4 above the keyboard is turned off to
select the monitor as the display device. (See “Setting the
DIP Switches” in Chapter 1 for instructions.)
5.
Turn off the power switches on both the main unit and
the monitor. Then check the electrical outlet for power.
Plug a portable lamp into the outlet you are using for the
monitor and turn it on to see if the outlet supplies power.
The Computer Does Not Respond
If the computer does not respond to something you enter
from the keyboard, try the following:
1.
Wait a few seconds. Some operations take longer to
perform than others. For example, a spreadsheet program
takes longer to recalculate an entire spreadsheet than to
record one figure. Also, BASIC programs that have many
calculations to perform can take several minutes, or even
hours. Be aware of the task the computer is performing and
judge the time accordingly.
2.
If the computer remains locked up, follow the steps in
Chapter 3 under ‘Resetting the Computer.”
Low Battery Problems
If the battery runs low, recharge it according to the
instructions in Chapter 3.
The battery inside the Equity LT should last as long as the
computer does. If, however, the battery seems to be running
low sooner than it should after being recharged, you can test it
by following the steps on the next page.
Troubleshooting
B-3