Filter
Top Products
Saving Configuration Changes
Summit 200 Series Switch Installation and User Guide 309
where:
If you do not specify a reboot time, the reboot occurs immediately following the command, and any
previously scheduled reboots are cancelled. To cancel a previously scheduled reboot, use the
cancel
option.
To reboot only an individual slot in the stack, issue the following command:
reboot slot <n> {time <date> <time> | cancel}
where:
If you do not specify a reboot time, the reboot occurs immediately following the command, and any
previously scheduled reboots are cancelled. To cancel a previously scheduled reboot, use the
cancel
option.
Saving Configuration Changes
The configuration is the customized set of parameters that you have selected to run on the switch. As
you make configuration changes, the new settings are stored in run-time memory. Settings that are
stored in run-time memory are not retained by the switch when the switch is rebooted. To retain the
settings, and have them load when you reboot the switch, you must save the configuration to
nonvolatile storage.
The switch can store two different configurations: a primary and a secondary. When you save
configuration changes, you can select into which configuration area you want the changes saved. If you
do not specify the configuration area, the changes are saved to the configuration area currently in use.
If you have made a mistake, or you must revert to the configuration as it was before you started
making changes, you can tell the switch to use the secondary configuration on the next reboot.
To save the configuration, use the following command:
save {configuration} {primary | secondary}
To use the configuration, use the following command:
use configuration [primary | secondary]
The configuration takes effect on the next reboot.
date
Specifies the date when the switch will be rebooted The date is
entered in the format
mm/dd/yyyy.
time
Specifies the time of day, using a 24-hour clock, when the switch
will be rebooted. The time is entered in the format
hh:mm:ss.
slot <n>
Specifies the slot number. Valid entries are from 1 to 8.
date
Specifies the date when the switch will be rebooted The date is
entered in the format
mm/dd/yyyy.
time
Specifies the time of day, using a 24-hour clock, when the switch
will be rebooted. The time is entered in the format
hh:mm:ss.