Filter
Top Products
XTP T UWP 302 • Installation and Operation 14
Remote power
The XTP T UWP 302 can be powered remotely through an XTP Power Injector or through
an XTP matrix switcher.
ATTENTION: XTP remote power is intended for indoor use only. No part of the network
that uses XTP remote power should be routed outdoors.
Power injector
To power the XTP T UWP 302 remotely with an XTP Power Injector, power one device
locally (see Local power on page 13) and connect an XTP Power Injector to the XTP
cable run along the XTP ports (see the XTP Power Injector User Guide for more installation
information).
Ext
ron
X
TP T UWP 302
Univ
ersal XTP Transmitter
POWER
12V
HDMI
--A MAX
R
x
GTx
RS-232 IR
RL
RxT
x
-+ -+
1
2
AUDIO
OFF
ON
AUDIO
S/PDIF
RESET
LAN
SIG
LINK
XTP IN
OVER XTP
OUTPUTS
RELAYS
ACT
LINK
S
IG
LINK
XTP IN
XTP
PWR
XTP PWR
100-240V
50/60 Hz
---A MAX
Extron
XTP R HDMI
XTP Receiver
Extron
XTP PI 100
XTP Power
Injector
CAT 5-Type
Cable
REMOTE
POWER
12V Local Power
Supply
AUDIO IN
PWRH DCP HDMIVGA
HDMI IN
VGA IN
Figure 15. Typical Pont-to-point Application with Remote Power
NOTE: The power injector provides remote power up to 330 feet with a CATx cable with
24 AWG wire.
Direct power from an XTP matrix switcher
XTP matrix switchers have a fixed amount of power available to provide remote power to
connected XTP devices (see XTP matrix switcher use guide for more details). To manage
available power from the XTP matrix switcher, use the XTP System Configuration Software
on the XTP matrix switcher.