Filter
Top Products
XTP T UWP 302 • SIS Configuration and Control 21
Command ASCII Command
(Host to Device)
Response
(Device to Host)
Additional Description
EDID Commands
NOTE: For EDID management, use the XTP System Configuration Software (see EDID Minder on page 33).
Advanced Configuration Commands
HDCP authorized device (HDMI input only)
HDCP authorized device On
EE1HDCP} HdcpE1]
HDCP authorized device on
(default).
HDCP authorized device Off
EE0HDCP} HdcpE0]
HDCP authorized device off.
Query HDCP authorized
device status
EEHDCP} HdcpEX$]
View the HDCP authorized
device status.
Test pattern
Set a test pattern
X1)J TstX1)]
Set a test pattern or disable
one.
View the current test pattern
J
Tst
X1)]
View the current test pattern.
Factory defaults
System reset
EZXXX} Zpx]
Resets unit to factory default.
Status
View input signal presence
0LS
Frq
X1!X1!]
View the input signal presence
of each input.
Query HDCP input
EIHDCP} HdcpI0X1@]
View the HDCP status of the
HDMI input.
Query firmware version
Q
x.xx
]
View the firmware version.
Query full firmware version
*Q
x.xx.xxxx
]
View the full firmware version.
Query part number
N
60-1358-12
] or
60-1358-13]
View the device part number.
NOTE: X! = Input selection 1 = VGA (default)
2 = HDMI
X$ = HDCP Authorization 0 = HDCP authorization off
1 = HDCP authorization on (default)
X1) = Color bar test pattern 0 = disable (default)
1 = 720p @ 50 Hz
3 = 720p @ 60 Hz
5 = 1080p @ 60 Hz
X1! = HDCP status 0 = no source connected
1 = HDCP compliant source
2 = non-HDCP compliant source
X1@ = Video signal status 0 = video or TMDS not detected
1 = video or TMDS detected