Filter
Top Products
XTP T UWP 302 • Installation and Operation 3
Installation and
Operation
This section contains information for mounting, connecting, and wiring the XTP T UWP 302.
Topics in this section include:
• Installation Overview
• Installing the Mud Ring or Junction Box
• Rear and Side Panel Connectors
• Mounting the XTP T UWP 302
• Front Panel Connectors
• Making Connections
• Operation
Installation Overview
The XTP T UWP 302 can be installed into the provided mud ring or an electrical UL Listed
junction box.
1. Prepare the mounting surface.
CAUTION: Risk of personal injury. Failure to check the items listed below may result
in personal injury.
ATTENTION: Failure to check the items listed below may result in property damage.
a. Ensure there are no utility cables or pipes at the intended location that might be
damaged or cause injury when installing the device.
b. Check that the installation meets the building, electrical, and safety codes.
c. Ensure there is sufficient space behind the device.
d. Choose a location that will allow cable runs without interference.
NOTES:
• Cables may need to be installed in the wall or conduits before installation.
• The mud ring does not require attachment to wall studs.
• For junction boxes, refer to the manufacturer for more installation requirements.
2. Cut a hole in the mounting surface (see Cutting an Opening in the Mounting Surface
on page 4).
3. Install the mud ring or junction box in the mounting surface (see Installing the Mud Ring
on page 4 or Installing the UL-Certified Junction Box on page 6).
4. Route and connect cables to the rear and side panel connectors (see Rear and Side
Panel Connectors on page 6).
5. Mount the XTP T UWP 302 to the mud ring or junction box (see Mounting the
XTP T UPW 302 on page 8).
6. Connect inputs to the front panel connectors (see Front Panel Connections on page 9).