Filter
Top Products
TeamPoS 3000 XL and XL
2
Installation
D900000145 Issue 3 5-65
4. With the Keypad/MSR facing down, remove the back cover by pushing in on the latches
at the bottom and long edge then lift off the back cover. (The MSR has one latch.)
5. With Keypad/MSR face down, slide it into the side of the LCD so that the guide pins
slide into the slots. Make sure that the connector cable is not pinched between the
Keypad/MSR and the LCD. Fasten with screws.
Guide Pins in
Slot
Anchoring
Screws
M3x0.5
panhead
phillips SEMS
8mm
Mounting Edge
Latch
Bottom Edge
Latches