Filter
Top Products
TeamPoS 3000 XL and XL
2
Installation
D900000145 Issue 3 5-27
The Powered USB I/O board has 3, 12V powered USB connections installed in the top slot
(the long slot).
1. Remove the rear panel. (See Section 5.1.2).
2. Disconnect the AC power cord from the controller.
3. Remove the front panel (See Section 5.1.1.).
4. Unseat the motherboard (See Section 5.2.).
5. Remove the backplane assembly (See Section 5.9.).
6. Remove top filler plate by first removing the retainer clip at the center of the filler
plate. To do this pull outward on the black plug. Retain the retainer clip.
7. Remove 2 mounting screws holding the upper filler plate. Retain the screws.
8. Invert the USB board so that the ports face away from the backplane. Connect the
white cable to J11 connector. The J11 connector is labeled. It is the second white
connector from the left when looking down at the backplane from the rear.
Retainer clip
Filler Plate
Mounting Screws