Filter
Top Products
Installation Instructions on connecting and disconnecting cables
12 A26361-K646-Z102-1-7619
3.3 Instructions on connecting and disconnecting
cables
!
Be sure to read the documentation on the external devices before connecting them.
Do not connect or disconnect cables during a thunderstorm.
Always take hold of the actual plug. Never unplug a cable by pulling the cable itself.
Connect and disconnect the cables in the order described below.
Connecting cables
• Turn off all power and equipment switches.
• Pull all power plugs out of the grounded power outlets.
• Plug all cables into the server and peripherals.
• Plug all data communication cables into the utility sockets.
• Plug all power cables into the grounded power outlets.
Disconnecting cables
• Turn off all power and equipment switches.
• Pull all power plugs out of the grounded power outlets.
• Unplug all data communication cables from the utility sockets.
• Disconnect the relevant cables at the server and at the peripherals.
3.4 Setting up the tower server
If you set up the server at the intended location, please ensure that:
• the device is protected from direct sunlight.
• minimum clearances for operation and maintenance are observed.
• the server is accessible from the rear to connect external devices.
• the power plug is easily accessible without risk of danger.
• there is a clearance of at least 200 mm in front of and behind the server to ensure adequate
ventilation.