Filter
Top Products
Extended Configuration Menu
Web-Based Management Interface
Intelligent Blade Panel Module
130
User Login Configuration screen. If you need to create a new login list for the user, you would
do so on the Login Configuration screen.
The pre-configured users, admin and guest, are assigned to a pre-configured list named
defaultList, which you may not delete. All newly created users are also assigned to the
defaultList until you specifically assign them to a different list.
A user that does not have an account configured on the IBP is termed the 'default' or
'non-configured' user. If you assign the 'non-configured user' to a login list that specifies
authentication via the RADIUS server, you will not need to create an account for all users on
each IBP. However, by default the 'non-configured user' is assigned to 'defaultList', which by
default uses local authentication.
Selection Criteria
User - Select the user you want to assign to a login list. Note that you must always
associate the admin user with the default list. This forces the admin user to always be
authenticated locally to prevent full lockout from IBP’s configuration. If you assign a user to
a login list that requires remote authentication, the user's access to the IBP from all CLI,
web, and telnet sessions will be blocked until the authentication is complete. Refer to the
discussion of maximum delay in the RADIUS configuration help.
Configurable Data
Authentication List - Select the authentication login list you want to assign to the user for
system login.
Command Buttons
Submit - Sends the updated screen to the IBP and causes the changes to take effect on
the IBP. These changes will not be retained across a power cycle unless you perform a
save.
Refresh - Updates the information on the page.