Filter
Top Products
Groups Administration
Web-Based Management Interface
Intelligent Blade Panel Module
55
6.2.1.5 Managing Service VLAN Groups
6.2.1.5.1. Configuring Service VLAN Configuration Page
Selection Criteria
Service VLAN Name - You can use this screen to reconfigure an existing Service VLAN,
or to create a new one. Use this pull down menu to select one of the existing Service
VLANs, or select 'Create' to add a new one.
Configurable Data
Service VLAN Name – Specify the Service VLAN Name for the new Service VLAN. It can
be up to 32 alphanumeric characters, including blanks.
Service VLAN ID - Specify the VLAN Identifier for the new Service VLAN. (You can only
enter data in this field when you are creating a new Service VLAN.) The range of the VLAN
ID is from 1 to 4094.
Uplink Set Name – Specify the uplink set for the external connection. If the pulldown
menu shows "----------", it means that there is no available uplink set.
Participation – Use the pull-down menu to configure a interface to participate in this
Service VLAN. The factory default is ‘Exclude’. The possible values are:
- Include: This interface is the member of the Service VLAN.
- Exclude: This interface is not the member of the Service VLAN.
Non-Configurable Data
Slot/Port - Indicates the interface.
Type – The interface type. Type could be Internal.
Status - Indicates the current value of the participation parameter for the interface.
Command Buttons
Submit - Update the IBP with the values on this screen. If you want the IBP to retain the
new values across a power cycle, you must perform a save.
Delete - Delete this Service VLAN.