Filter
Top Products
Main Menu
Web-Based Management Interface
Intelligent Blade Panel Module
44
6.2 Main Menu
6.2.1 Groups Administration
6.2.1.1 Managing Uplink Sets
6.2.1.1.1. Configuring Uplink Set Configuration Page
An "Uplink Set" is defined as a set of 1 to n external (uplink) ports, which is be used in port
group definitions to connect a group of server blades to the customer's LAN. The purpose of
the uplink set configuration is to create groups, and to add or modify the existing external ports
to groups. Link state, port backup, and IGMP snooping of the uplink set groups can be
configured in this page.
Selection Criteria
Uplink Set Name – Use this pull-down menu to select one of the existing uplink set.
Configurable Data
Uplink Set Name – Input the uplink set name to create a new group. It can be up to 32
alphanumeric characters, including blanks.
Link State – Use this pull-down menu to configure link state.
Port Backup – Use this pull-down menu to configure port backup
IGMP snooping –Use this pull-down menu to configure IGMP snooping
Participation –Use this field to specify whether a interface will participate in this uplink set.
The factory default is 'Exclude'. The possible values are:
- Include: This interface is the member of the uplink set.
- Exclude: This interface is not the member of the uplink set.
Non-Configurable Data
Slot/Port – The interface
Type – The interface type. Type should be external.
Status – The interface is belong to this port group or not.
Command Buttons