Filter
Top Products
Logical bus address Instance number Driver name
"/pci@1,700000/pci@0,1/FJSV,e4ta@6,1" 3 fjgi
"/pci@3,700000/pci@0/FJSV,e2sa@4" 4 fjgi
"/pci@3,700000/pci@0/FJSV,e2sa@4,1" 5 fjgi
"/pci@2,600000/pci@0/FJSV,e2ta@4" 6 fjgi
"/pci@2,600000/pci@0/FJSV,e2ta@4,1" 7 fjgi
"/pci@4,600000/pci@0/FJSV,e4tb@4" 8 fjgi
"/pci@4,600000/pci@0/FJSV,e4tb@4,1" 9 fjgi
"/pci@4,600000/pci@0,1/FJSV,e4tb@6" 10 fjgi
"/pci@4,600000/pci@0,1/FJSV,e4tb@6,1" 11 fjgi
The relationship of logical bus addresses to physical slot numbers differs in each server. To determine the relationship, please refer to
"Appendix G PCI Slot Number and Device Name".
3.5 Operation Mode Setup
This section explains how to edit the fjgi.conf configuration file or use the command line to change the operation mode of FUJITSU PCI
GigabitEthernet interfaces. Setup of the following operation modes are described below.
- 3.5.1 Setting the fjgi.conf File
- 3.5.2 JumboFrame Setup
- 3.5.3 Using the ndd(1M) command
- 3.5.4 Using the dladm(1M) command
- 3.5.5 FCode Settings
3.5.1 Setting the fjgi.conf File
Usually, setup of the fjgi.conf file is unnecessary. Default settings are appropriate in most environments.
The following examples show cases when the fjgi.conf file needs to be modified.
Example:
- When the remote device does not support Auto-Negotiation.
In this case, please set the same mode of operation for the local and remote devices.
- When Auto-Negotiation is used, but it is desirable to use a specific setting value, different from the default value (for example, when
you want to set the speed to 100Mbps in order to keep the CPU load by the network low).
- When JumboFrame is used.
For details, please refer to "3.5.2 JumboFrame Setup".
Using Auto-Negotiation (the default settings) is recommended for speed, duplex, and flow control.
To change the operation mode, there are two methods; "Method 1: Setting method of new style" and "Method 2: Setting method of old
style". When there is a mistake in parent and unit-address setting by the "Method 2", warning messages may be displayed repeatedly.
Therefore the "Method 1: Setting method of new style" is recommended.
When editing the fjgi.conf file, please review the [Cautions] in the following sections.
- Method 1: Setting method of new style (Recommended)
[Parameter List]
- 17 -