Filter
Top Products
- Execute the following command to set Half Duplex communication, 10Mbps.
ok transfer-speed=10
ok half-duplex
- Execute the following command to display the current settings.
ok .properties
The following example shows the current settings of a SE0X7GD1X card installed in a SPARC Enterprise M9000.
{6} ok cd /pci@4,600000/pci@0/FJSV,e2ta@4
{6} ok .properties
duplex half <-- (*1)
transfer-speed 0000000a <-- (*2)
status okay
assigned-addresses 82032010 00000000 00100000 00000000 00010000
82032018 00000000 00110000 00000000 00010000
82032030 00000000 00120000 00000000 00010000
local-mac-address 00 e0 ed 12 a8 3c
fjgiga-rev 000000c3
product-name FJSV,e2ta
device_type network
address-bits 00000030
max-frame-size 00004000
reg 00032000 00000000 00000000 00000000 00000000
03032010 00000000 00000000 00000000 00010000
03032018 00000000 00000000 00000000 00010000
02032030 00000000 00000000 00000000 00010000
model Broadcom,BCM5715C
compatible fjgi
name FJSV,e2ta
media-type 1000BASE-T
version 1.0
fcode-rom-offset 00000000
66mhz-capable
fast-back-to-back
devsel-speed 00000001
latency-timer 00000040
max-latency 00000000
min-grant 00000040
interrupts 00000001
cache-line-size 00000010
class-code 00020000
subsystem-id 00000066
subsystem-vendor-id 00001374
revision-id 000000a3
device-id 00001678
vendor-id 000014e4
*1: Displayed only when half-duplex is set.
*2: Displayed only when transfer-speed is set to a specific value. [10Mbps: 0xa, 100Mbps: 0x64, 1000Mbps: 0x3e8]
Note: *1 and *2 are not displayed in the default configuration.
Note
- Changes to FCode settings are lost after executing the reset-all command from the ok prompt (See "How to Return to Default
FCode Settings (Auto-Negotiation Mode)"), or after power cycling the system.
- 36 -