Filter
Top Products
aggr1 net3 124 16.03K 147 18.82K
aggr1 net4 122 15.62K 148 18.94K
*: net2, net3, and net4 are the vanity name of fjgi0, fjgi1, and fjgi2, respectively.
Note
- For more information about this command, please refer to the "man pages section 1M: System Administration Commands" of Oracle
Documentation.
4.3 Notes
This section explains notes for using the LinkAggregation function.
- Only TCP/IP connection is supported.
- If a VLAN interface is made with the LinkAggregation feature, the following must be satisfied.
(The number of VLAN interfaces) * (the number of physical interfaces in group) * (the number of
groups) <= 1024
If this is not satisfied, the system may not work correctly due to lack of memory resource.
- The link speed must be the same among the member interfaces in a LinkAggregation Group, and duplex mode must be set to full.
- In a cluster system, fail-over of LinkAggregation interfaces on a public LAN is not supported.
- When the interfaces are connected to a LAN switch, it is necessary to enable the LinkAggregation function on the LAN switch. For
more information about the LAN switch and the LinkAggregation function, please refer to the specifications of each LAN switch.
- It is necessary to inactivate corresponding LinkAggregation Groups with the ifconfig(1M) command before DR (Dynamic
Reconfiguration) or PCI Hot Plug is performed.
- It is necessary to activate corresponding LinkAggregation Groups with the ifconfig(1M) command after DR or PCI Hot Plug is
completed.
- VLAN interfaces can not be specified directly as interfaces belonging to the LinkAggregation Group. It is necessary to create the
VLAN interface for the aggregated interface by the usual VLAN interface creation procedure (ifconfig(1M) command or dladm(1M)
command (Solaris 11 only), etc) to use the VLAN interface with LinkAggregation.
- 56 -