Filter
Top Products
No Message Cause Workaround
15 DETACH failed ([detail]) Unloading of the driver failed.
After disabling the driver, re-do the
process (disconnect in Dynamic
Reconfiguration, etc.) If this message is
still displayed, report to your service
provider.
16
failed to allocate([detail])
Allocating of the memory
resource failed.
Installed physical memory may be
insufficient. If this is not the cause, report
this error to your service provider.
17
ddi_dma_alloc_handle failed([detail])
Allocating of the DMA
resource failed.
18 ddi_dma_addr_bind_handle failed([detail])
19 (Other messages)
There is a possibility of driver
internal bug or hardware
failure.
Report the error to your service provider.
Table A.3 Console Messages from the FUJITSU PCI GigabitEthernet Driver
No Message Cause Workaround
1 network connection down Link is down
Check the cable connection and the
switch configuration.
2
network connection up using portA
autonegotiation:[A]
speed: [B]
flowctrl: [C]
duplex mode: [D]
(role: [E]) (*1)
Link has become up
There is no problem.
[A]
yes: Auto-Negotiation is on
no: Auto-Negotiation is off
[B]
1000: Transmitting and
receiving data at 1000Mbps
100: Transmitting and
receiving data at 100Mbps
10: Transmitting and receiving
data at 10Mbps
[C]
symmetric: Send/accept
Flowcontrol requests to/from
the remote device.
remote send: Does not send
Flowcontol request. Only
accept Flowcontrol requests
from the remote device.
local send: Only send
Flowcontrol requests. Does not
accept Flowcontrol requests
from the remote device.
none: Disabled
[D]
full: Transmitting and receiving
data in full duplex mode
half: Transmitting and
receiving data in half duplex
mode
[E]
- 59 -