Filter
Top Products
- How to Return to Default FCode Settings (Auto-Negotiation Mode):
- To return to default FCode settings, execute the following command from the ok prompt, or power cycle the system.
ok reset-all
3.6 Network Installation
See the document "
Install Server Build Guide I/O Device Driver (SPARC Enterprise)
" for the installation procedure.
3.7 VLAN Interface Setup
This section provides information about the VLAN interface and setting up the VLAN interface.
- 3.7.1 IEEE 802.1Q TagVLAN
- 3.7.2 Setting Up the VLAN Interface
3.7.1 IEEE 802.1Q TagVLAN
The IEEE 802.1Q TagVLAN function is described in the following.
- IEEE 802.1Q TagVLAN
- The TagVLAN function provides the ability to create two or more separate networks that share a single physical interface. Virtual
interfaces are created by assigning VLAN IDs (VIDs) to a physical interface. Communication between different VID interfaces on
the same host is not allowed. The following example shows a comparison of the networks created without and with the TagVLAN
feature.
Figure 3.1 Example of using VLAN
By using a VLAN, traffic management of two or more networks on a single physical interface can be done.
In order to create a VLAN environment, a switch capable of supporting a VLAN setup (VID and Tagged/Untagged setting) is required.
- 37 -