Filter
Top Products
MX130 S2 Upgrade and Maintenance Manual 41
Important information
Exiting the hibernate/idle state (S4 mode)
You switch on the system again either manually using the On/Off button or using
the WOL function (WOL= Wake-up On LAN).
To do this, a Magic Packet with the MAC address of the system to be woken up
is sent to the internal LAN controller.
You will find the valid MAC address for your device in the BIOS:
Ê During boot press [F2] to enter BIOS.
Ê Navigate to Main - System Information and press [Enter].
The MAC address is shown under Network Controller Details.
I Alternatively, you can find out the MAC address valid for your device
using the command line tool IPCONFIG.
Ê Open the command line tool using C:\Windows\System32\cmd.exe
and enter the following command:
ipconfig /all
LINUX operating systems
Activation
Ê To activate S4 mode, enter the following command:
resume=/dev/sdxx
Using this command, the memory area in which the data is saved is
assigned at the same time.
Execution
Using the following command, the system is switched off and brought into S4
mode:
echo -n "disk" > /sys/power/state
Exiting the hibernate/idle state (S4 mode)
You switch on the system again either manually using the On/Off button or using
the WOL function (WOL= Wake-up On LAN).
To do this, a Magic Packet with the MAC address of the system to be woken up
is sent to the internal LAN controller.