Filter
Top Products
MX130 S2 Upgrade and Maintenance Manual 63
Basic software procedures
Ê Press the On / Off button to start up the server.
The system will detect the USB stick and the BIOS recovery process will be
performed.
V CAUTION!
Do not interrupt the BIOS upgrade process after it has started. If the
process is interrupted, the system BIOS may be permanently
corrupted.
Ê After completion of the flash process, shut down the server.
Ê Open the side cover as described in section "Closing the server" on
page 54.
Ê Disable BIOS recovery mode using the onboard jumpers:
I For detailed information on jumper settings, refer to section "Onboard
settings" on page 250.
Ê Close the side cover as described in section "Closing the server" on
page 54.
5.2.2 Updating RAID controller firmware
The onboard RAID controller firmware is updated with the system board BIOS.
Please proceed as described in section "Updating the system board BIOS" on
page 62.