Filter
Top Products
3.8 Push Mode Automatic Logout Time Settings
fi-5000N Operator’s Guide 23
Installing the fi-5000N
3
3.8 Push Mode Automatic Logout Time Settings
This setting applies only to Push mode scanning. After performing a scanning, if no other opera-
tions are done after a certain period of time, the current user will be logged out automatically. You
can specify this waiting time by following the procedure below.
The default time limit for an automatic logout is 0 second.
1. Open the fi-5000N’s cover and press the [SET] key.
The following settings screen appears.
2. With the [L] key, select "Administrator Setup", and press the [ENT] key.
The screen to enter the Administrator's PIN (personal iden-
tification number) appears.
3. Enter the Administrator PIN (the default setting is "5000"), and press the [ENT] key.
The following screen appears.
4. With the [L] key, select "Auto logout time", and press the [ENT] key.
The following screen appears.
5. With the keyboard, input the waiting time before logging out (from 0 to 60 seconds)
and press the [ENT] key.
The following screen appears.
With this, the automatic log out time setting is done.
The setting will take effect from the next scanning.
Setup
Register Finger
Change PIN Code
Show Network Config
PIN:_
Cancel:[ESC]
Administrator Setup
Configure Network
Pull Mode Authentic
Auto Logout Time
Auto logout time
(0-60)[seconds]
0_
Auto logout time
setting changed