Filter
Top Products
99
www.gateway.com
3 Remove the jumper across pins 2-3 of jumper J1H2 (Pass Clr), then place the jumper
across pins 1-2.
4 Reconnect the power cords and turn on the server. The BIOS password(s) is cleared.
5 Turn off the server, then disconnect the power cords and all other cables connected
to the server.
6 Place the jumper back onto pins 2-3.
7 Follow the instructions in “Closing the server case” on page 39.
Caution Moving the jumper while the power is on can damage your server.
Always turn off the server and unplug the power cords and all other
cables before changing the jumper.