Filter
Top Products
50
www.gateway.com
Installing a CD or DVD drive
To install a CD or DVD drive:
1 Follow the instructions in “Preventing static electricity discharge” on page 37. Make
sure that you turn off the server, then unplug the power cord and all other cables
connected to the server.
2 Follow the instructions in “Opening the server case” on page 38.
3 Unlock the bezel (if necessary) and remove it by pulling it from the chassis.
4 Remove the slim-line drive bay filler panel.
- OR -
Remove the CD/DVD drive carrier by pressing the blue lever at the back of the carrier
and pushing the carrier out the front of the server.
5 Place the CD or DVD drive in the drive carrier (included with your server) by aligning
the two holes in the left side of the drive with the two alignment pins in the carrier,
then lowering the right side of the drive into the carrier until it clicks into place.
Caution The CD or DVD drive is not hot-swappable. Before installing or
removing the drive, make sure that power is turned off and the power
cord is unplugged.
Interposer board
CD or DVD drive
Screws
Drive carrier