Filter
Top Products
13
www.gateway.com
Mounting your server into a cabinet
The cabinet mounting hardware included with your server should be used with EIA-310-D
standard 4-post cabinets that have front and back vertical posts. The L-shaped cabinet
mounting brackets can be used for mid-mounting on a 2-post cabinet, but that procedure
is not covered here. If your cabinet is a different type, obtain mounting hardware from
the cabinet manufacturer.
Rackmount kit contents:
■ Server rails (2)
■ Cabinet rails (2)
■ L brackets (2, not used for this type of installation)
■ Fastener pack (1)
■ Small screws (4, #6-32 × 3/16-inch)
■ Medium screws (8, #10-32 × ½-inch)
■ Large screws (2, #10-32 × 7/8-inch)
■ Disk guides (2)
■ Handle spacers (2)
■ Nut bars (4)
Caution Before attaching cabinet accessories, make sure that the server is
turned off and all power cords are unplugged.
Caution The cabinet must provide sufficient airflow to the front of the server
to maintain correct cooling. It must also include ventilation sufficient
to exhaust a maximum of 1200 BTUs per hour for this server.