Filter
Top Products
76
www.gateway.com
Installing a processor
The 9315 server is compatible with Intel
®
Xeon processors with a front side bus frequency
of 800 MHz and a minimum speed of 2.8 GHz. The server automatically detects the
processors each time you turn it on. Whenever you install new processors, you should
first install the most current version of the BIOS. For instructions, see “Updating the BIOS”
on page 93.
To install or replace a processor:
1 Install the most current BIOS version. For instructions, see “Updating the BIOS” on
page 93.
2 Follow the instructions in “Preventing static electricity discharge” on page 37. Make
sure that you turn off the server, then unplug the power cord and all other cables
connected to the server.
3 Follow the instructions in “Opening the server case” on page 38.
4 Follow the instructions in “Removing the processor air duct” on page 41.
Warning Processors and heat sinks may be hot if the computer has been
running. Before replacing a processor or heat sink, allow them to cool
for several minutes.
Caution A heat sink must be installed on the processor. Installing a processor
without a heat sink could damage the processor.
Important You must have a processor in the CPU 1 socket or your server will
not start.
If you are upgrading your server from one processor to two, you may
need to reconfigure your operating system so it can recognize the
additional processor. For more information, see your operating
system’s documentation.