CHAPTER 6: Troubleshooting
76
You see a “Disk is full” error message
• Delete unnecessary files on the diskette.
• Try a different diskette. Occasionally diskettes are
flawed and cannot be read by the diskette drive.
• Run Error Checking on the diskette. For more
information, see “Checking the hard drive for errors”
on page 63.
You see a “Non-system disk” or “Disk error” error message
• Eject the diskette from the diskette drive, then press
E
NTER.
• Make sure that the diskette you are using is
IBM-compatible.
The diskette drive LED is lit continuously
• Remove the diskette from the drive. If the light stays
on, try restarting your computer.
DVD drives
• See “CD or DVD drives” on page 73.
Ethernet
You cannot see the other computers on your network
• Make sure that your Ethernet cable is plugged into the
Ethernet jack on your computer. Make sure that the
other end is plugged into a router.
• Make sure that all computers are plugged into a
powered electrical outlet and turned on.
• Make sure that the router is plugged into a powered
electrical outlet and turned on. Most routers have lights
that indicate they are working. For more information,
see the documentation that came with your router.
• Make sure that all computers on your network have the
same workgroup name.
• Make sure that all computers are using the same Subnet
Mask.
• If you assigned IP addresses to the computers, make
sure that all computers have different IP addresses. For
home networks, IP addresses should be 192.168.N.N
where N is a number you assign between 0 and 254.
The first N should be the same for all computers on your
network and the second N should be different for all
computers on your network.
8512032.book Page 76 Tuesday, January 9, 2007 1:47 PM