Filter
Top Products
GFK-2251 3-1
Hardware Installation
This chapter describes the procedures for the safe location and securing of the Panel C
industrial computer. The Panel C industrial computers have been designed to ensure
simple installation of the system.
A single cut-out in the mounting panel is all that is required when mounting the industrial
computer. No extra mounting holes are needed. Instead, 10 clips are supplied and are
used to secure the unit from behind the mounting panel.
This chapter also describes how to install ISA and PCI cards.
Warnings for Class 1 Division 2 Approval
■ Input and output wiring methods must be in accordance with Class I, Division 2 wiring
methods and in accordance with the authority having jurisdiction.
■ This equipment is suitable for use in Class I, Division 2, Groups A, B, C, or D or non-
hazardous locations only.
■ WARNING - Explosion Hazard - Substitution of components may impair suitability for
Class 1 Division 2.
■ WARNING - Explosion Hazard - Do not disconnect equipment unless power has been
switched off or the area is known to be non-hazardous.
■ WARNING - Explosion Hazard - Do not replace equipment unless power has been
switched off or the area is known to be non-hazardous.
■ Equipment shall be connected to no greater than a 20 Amp branch circuit.
■ Do not install or remove SCSI devices or cards while circuit is alive.
■ WARNING – Battery may explode if mistreated. Do not recharge, disassemble or
dispose of in fire.
■ Replace battery with Duracell part no. 2032 only. Use of another battery may present
a risk of fire or explosion.
■ Keyboard and mouse are to be used for initial programming only and not to be left
connected.
■ For non-incendive field wiring, use only 64MB flash card
SANDISK SDCFBI-64-101-00.
Note: The proper method for removing power from the unit is to switch off power at the
circuit breaker.
3
Chapter